|
[TERM]preload:プレロード:collapsible tube:コラプシブルチューブ:CLEARANCEクリアランス:調整:（予圧、ガタ、end play,遊び,バックラッシュ）JK1302p122有馬宏
preload:プレロード:collapsible tube:コラプシブルチューブ:
wheel bearing clearance[ end play of front wheel hub]
Installation tolerance of value when new : 0.01~0.02 mm
Wear limit or limit value : 0.05mm
BZ:
CLEARANCEクリアランス:
|
コメント（15）
コラプシブルチューブにおける圧力波の伝播解析
ci.nii.ac.jp/naid/110004628988 - キャッシュ
本論文では,生体内のコラプシブルチューブに対する圧力波伝播解析の基礎として,一様断面を有する有限長さの真直ぐなコラプシブルチューブを対象に,チューブ内に流体の流動がない場合の波動方程式を導出し,表計算ソフトを用いて,差分化された波動方程式 ...
http://ci.nii.ac.jp/naid/110004628988
2013/1/27(日) 午前 6:22
変形したコラプシブルチューブ内 - 英和辞典・和英辞典 - Weblio辞書
ejje.weblio.jp › 英和辞典・和英辞典 › 専門用語対訳辞書 - キャッシュ
変形したコラプシブルチューブ内を英語に訳すと deformed collapsible tube - 約926万語ある英和辞典・和英辞典。発音・イディオムも分かる英語辞書。
2013/1/27(日) 午前 6:22
プレロード - 自動車整備士．
www.jidoshaseibishi.com/.../steering_gear_box2.html - キャッシュ
ウォーム・シャフトのプレロードの調整は、フロント・カバーのシムの厚さを変えて行うが、 プレロードが小さ過ぎるときは、このシムを（イ）する。 ボール・ナットとセクタとのバックラッシュの調整は、ステアリング・ホイールを 直進状態にして（ロ）をその軸方向に動かし ...
2013/1/27(日) 午前 6:24
Wheel Bearing Adjustment
www.nichols.nu/tip235.htm - キャッシュ - このページを訳す
An easy way to check the bearing play is to jack up the corner to be checked and grab the top and bottom of the tire. Shake back ... Porsche front wheel bearings, like those in most rear-drive cars, ideally should be set with no preload, and no end play. Since this is ... 5) Stop rotating the hub, and carefully loosen the locking nut until there is clearance between the nut and the tabbed washer. 6) By hand ...
2013/1/27(日) 午前 6:42
Front wheel bearing end play - PeachParts Mercedes ShopForum
www.peachparts.com/.../322075-... - アメリカ - キャッシュ - このページを訳す
2012/07/29 – Should have said inner ring of the outer bearing to collar. I have always done it by feel but ... Front wheel bearing end play ... Tighten the clamping nut well while simultaneously rotating the Hub to the extent that the Hub will be hard to turn. ( You are doing this to squash the grease out from between the Bearing and the Bearing
2013/1/27(日) 午前 6:42
Replace the upper bushing if readings are in excess
of .015" (0.38 mm).
http://www.dana.com/wps/wcm/connect/5cf402804b289beeaaadfff859534476/DEXT-axsm0038_0511_SteerAxlesServiceManual_LR.pdf?MOD=AJPERES
2013/1/27(日) 午前 6:46
Front Wheel Bearing Procedure - Jaguar Forums - Jaguar Enthusiasts ...
www.jaguarforums.com/.../front-wheel-b...
1997 XJR Know generally how to do front wheel bearing but need procedure when re-t. ... The designated clearance is 0.025-0.08mm. ... nut with spanner with rotating the hub. tighten it up until the hub stop rotating. it would be easier to rotate the hub with brake disc. ... I'm sure that, technically speaking, Jaguar has an end-float spec for the front bearings. ...
2013/1/27(日) 午前 6:49
I run the the nut down, gently, to seat the bearings and then back off until I can just feel some play at the brake ...
2013/1/27(日) 午前 6:50
堅くては、重くて動かない。
緩くては、スムーズに動かない。
その絶妙な固定が大切なのだろう。
過度な発熱しない適度な調整
2013/1/27(日) 午前 6:55
Wheel Bearing & Seal Service
www.aa1car.com/library/.../bf70348.htm
In a typical 3,400-lb. sedan, each pair of front-wheel bearings, as well as the rear- wheel or axle bearings, support 850 pounds ... With sealed wheel bearing and hub assembly, the seals cannot be replaced separately. .... Back off the nut one- sixth to one-fourth of a turn, or sufficiently to allow .001" to .007" of end play. ... Tighten the jam nut to remove thread clearance and to prevent the nut from backing off.
2013/1/27(日) 午前 6:59
Wheel Bearing Replacement
www.stlaroc.com/features/whlbear.html
Raise the front end of the car on a hoist or safely support it on jack stands and remove the wheel. ... Jerk the rotor assembly to loosen the washer and outer wheel bearing (brakes may have to be backed off). Push the ... Using a clean solvent and clean dry cloth, remove oil, grease and dirt from the hub cavity, dust cover and spindle. ...
2013/1/27(日) 午前 7:02
Back off the adjusting nut 1/16 to 1/8 turn, or to the nearest locking hole, or enough so that the wheel rotates freely with 0.001 inch to 0.010 inch end play.
2013/1/27(日) 午前 7:02
Radial Play (Internal Clearance) in Ball Bearings | AST Bearings
www.astbearings.com/ball-bearings-radia... - キャッシュ - このページを訳す
White Paper on Ball Bearings; Radial Play; Internal Clearance; Axial Play; End Play; Contact Angle; Fitting; Loading; ... the internal geometry of needle, roller, and tapered roller bearings is quite different than that found in ball bearings.
2013/1/27(日) 午前 7:24
Differentials and
Drive Axles
http://webtools.delmarlearning.com/sample_chapters/21048CM-Ch_07.pdf
2013/1/27(日) 午前 7:54
Bearing preload spacer
http://webtools.delmarlearning.com/sample_chapters/21048CM-Ch_07.pdf
2013/1/27(日) 午前 7:59