BW:E70:Preset measurement ”Absolute compression” - 車QF - Yahoo!ブログ
BW:E70:Preset measurement ”Absolute compression”
Cables used
Diagnostic cable
TD cable
Pressure sensor cable at connection P2 with pressure sensor 25 bar
Test probe for gasoline engine (special tool no. 11 0 226)
Procedure
コメント（4）
トラックバック先の記事
http://wds.spaghetticoder.org/us/zinfo/SCM0104MM1214001.htm
2012/3/2(金) 午後 1:05
返信する
Operate the starter until the hold screen is active.
Close ”Preset measurement”. The test module runs an evaluating of the stored pressure readings,
2012/3/2(金) 午後 1:06
返信する
Connect the pressure sensor 25 bar to the test probe by means of a fast release coupling.
Enter the position (cylinder) of the measuring sensor in the ”Preset measurement”.
Operate the starter until the hold screen is active.
Close ”Preset measurement”. The test module runs an evaluating of the stored pressure readings,
Note
Prior to a renewed measurement, the hold screen must be deactivated and the fast release coupling released briefly. This releases the pressure in the measuring sens
2012/3/3(土) 午後 4:39[ ATS ]返信する
25bar>25.5kgf/cm~2>2499.999975kPa>2.49MPa
2012/3/3(土) 午後 4:46[ ATS ]返信する