Within the control unit, the periodic duration of the individual increment gear segments is measured and statistically evaluated. For each point on the characteristic map, the maximum permissible rough running values are stored as a function of engine speed, load and engine temperature.
If these values are exceeded within a certain number of combustion cycles, the cylinders detected as faulty are stored in the fault code memory.
BW:E70:Carbon monoxide setting The carbon monoxide (CO) emission at idle speed is set by specifying CO calibration values using the DS tester on vehicles without emission (lambda) control. Procedure...
http://wds.spaghetticoder.org/us/zinfo/HEL0498FB1214_M0AUS.htm
2012/3/2(金) 午後 0:36
返信する
Within the control unit, the periodic duration of the individual increment gear segments is measured and statistically evaluated. For each point on the characteristic map, the maximum permissible rough running values are stored as a function of engine speed, load and engine temperature.
If these values are exceeded within a certain number of combustion cycles, the cylinders detected as faulty are stored in the fault code memory.
2012/3/2(金) 午後 0:39
返信する
トラックバックされた記事
BW:E70:Carbon monoxide setting
BW:E70:Carbon monoxide setting The carbon monoxide (CO) emission at idle speed is set by specifying CO calibration values using the DS tester on vehicles without emission (lambda) control. Procedure...
2012/3/2(金) 午後 1:01 [ 車QF ]
BW:E70:Preset measurement ”Absolute compression”
BW:E70:Preset measurement ”Absolute compression” Cables used Diagnostic cable TD cable Pressure sensor cable at connection P2 with pressure sensor 25 bar Test probe for gasoline engine (special tool no. 11 0 226) Procedure...
2012/3/2(金) 午後 1:04 [ 車QF ]
トラックバック先の記事