SLK 230 ESP ABS Limp Home Mode:P1861:P1860:C1102:C1103:C1200:C1120:C1202:C1025:
http://forums.mercedesclub.org.uk/showthread.php?t=75704
Hello
Great Forum people. Hello to you all.
This is my first post so hopefully it is in the right place.
I have an SLK230 2003.
The ABS and ESP lights came on a while ago, but I just ignored it as drove ok and I didn't have the cash (£60) for MB check.
Now, a week later it's gone into limp home mode.
I've tried changing the brake pedal switch (as shown/indicated here).
If I reset the errors by moving the steering wheel left then right it comes back on about a second or so after I start the engine.
When I start the car, at first I can change down the gears (automatic) but after a drive a litle bit (20 meters or so), it sticks in whichever gear indicated on the dash (1/2/3/4) and is in the limp home mode (1st gear).
I noticed that in my boot (trunk) was very wet, full of moisture. Lots of water in the spare wheel and the foam around he PSE unit is very wet.
I've taken it to an independent garage wgo has the Star system and got lots of error codes.
ESP
C1102-004,
C1103-002,
C1103-004,
C1103-016,
C1200,
C1120-004,
C1202,
C1025-002,
C1025-004
ETC
P2400,
P2401
ESM
P1861,
P1860
(plus more) but generally indicating fault with both rear speed sensors and yaw rate sensor, and ABS faulty.
The garage think it's an electrical problem, probably a lose connection somewhere.
I've removed the centre console, inspected YAW, acceleration and looked at the rear speed sensors.
Nothing obvious other that lots of water in the rear sensor plug where it connects to the main shell of the car on both sides.
I've dried this as best I could.
I still have the problem.
If I take it to dealer to do another diagnostic check, would they be able to give me any more information, is it worth it?
I'd like to repair it myself for the sense of achievement and also because I took it another Mecedes Specialist garage 6 months ago when it had exactly the same problem.
Not a good experience with them, as initial quote of £50 went to £600 without asking.
Then they replaced speed sensors and the ABS Pump Control Unit which I supplied second hand. Still that's another story.
Any ideas?
Should I take it to a dealer, could it be the ABS Pump/ESP controller again?
Thanks in advance for any help
SLK230:
コメント(19)
slk abs bas fault
Hi.
A friend of mine has slk 2002. Recently had abs / bas and sometimes the engine w /l ight on, intermitteny will stick in 2nd gear. After reading many posts on the forum i have replaced the battery and brkle light switch. I have a texa diag unit but just says can bus fault. Seem fine for 20 miles and the lights are back. After going on star machine at local indi a fault code of n/s/r abs sensor fault.
2011/2/4(金) 午後 10:45返信する
They replaced sensor and all good for aprox 20 miles. then light back. returned to indi who reported other sensor had water in boot for o/s/r sensor. i had them change the sensor. all ok for about 5 weeks then back to square 1. This time the car was the other side of the country so i arranged for the car to go in to a local indi. they reported that the wiring near the abs sensors is corroded causing the fault. they reported they cleaned the connectors and greased.
2011/2/4(金) 午後 10:47返信する
all ok for 50 miles then lights on and stuck in 2nd !!!!!! the car now recovered back so i could checlk this "corroded wire".
cut of the plugs on looms where abs sensors attach. No signs of corrosion. Solder joined the wiring and refitted boots. Done this as thou the plugs looked good didnt seem to lock together that great. greatly appreciatged.
2011/2/4(金) 午後 10:48返信する
checked wiring at abs pump, no signs of wet or corrosion. Fault code on texa is stored can bus fault again ????? is there any more connectors between rear sensor plug and control unit that are common for corrosion. Any help
2011/2/4(金) 午後 10:49返信する
Hi check both rear abs/rpm sensors very common, we have done loads water ingress to connectors .
http://forums.mercedesclub.org.uk/showthread.php?t=75704
2011/2/4(金) 午後 10:51返信する
Does the ABS pump run? if not check the fuses next to the battery, small black box, remove lid and there are some big cables in there with 50amp fuses if the fuse for the pump has blown then that could be the fault.
jib
__________________
04 W203 220CDi
00 SLK 230 Komp
95 C140 CL500
00 ML320
http://forums.mercedesclub.org.uk/showthread.php?t=75704
2011/2/4(金) 午後 10:52返信する
C1025:[HISTORY]
CAN バス:CANメッセージ ブレーキ・ランプ・SW / エンジン・
コントロール / ABSの異常
Fault 1/1 ID:5025
j50-100708-524.jpg
2011/2/27(日) 午後 8:50返信する
BAS:
025 545 48 32
Temic
j50-100708-530.jpg
2011/2/27(日) 午後 8:53返信する
ASR:
017 545 73 32
BOSCH
j50-100708-535.jpg
C1106:[HISTORY]
Wheel rpm sensor (RL) plausibility
ホイール回転数センサ(RL)の妥当性
2011/2/27(日) 午後 8:59返信する
C1107:[HISTORY]
Wheel rpm sensor (RR) plausibility
Fault 2/2 ID:5107
2011/2/27(日) 午後 9:01返信する
SLK230エンジンかからない』
99モデル、R170・SLK230、突然エンジンがかからなくなってしまう、暫く置いておくと普通にかかってしまうとの症状が繰り返し発生するとの事で入庫
http://www.enet.ne.jp/~002md9270/shuuri.htm
2012/3/3(土) 午前 8:10返信する
SLK230|電気廻り一式修理
http://motorize.jp/repair/repair-037.html
2012/3/3(土) 午前 9:38返信する
SLK230
信号待ちなどの停車中、走行中にエンストする。 セルが回らない。
再始動不能時に暫く再始動が出来ない。
再始動不能時にキースイッチONで燃料ポンプの作動音が聞こえない。
OVP オーバーロード(過電圧保護)リレー不良、燃料ポンプリレー不良の様な症状…
上記の様な症状の場合、W210やR170では定番ではないでしょうか。
このリレーユニットが怪しいですね。この商品はOVPリレー、燃料ポンプリレー等が一体モジュールとなっております。
他にもこのリレーユニットが故障すると、点火系・タイミング・コンプレッサーなどが、正常に作動しない場合等もございます。
http://www.centpia.co.jp/products/detail1658.html
2015/1/19(月) 午後 2:04返信する
ベンツ W210 E240 ステーションワゴン エンジン始動不能
http://ameblo.jp/current-tech/entry-10945602077.html
2015/1/19(月) 午後 2:07返信する
W210 R170 W463/純正 ヒューズボックス リレーユニット新品 (210-540-0072)
TT4
カスタマーレビューを書きませんか? 価格: ¥ 25,000
http://www.amazon.co.jp/W210-W463/純正-ヒューズボックス-リレーユニット新品-210-540-0072/dp/B00DNRC9XI
2015/1/19(月) 午後 2:10返信する
ベーシックモジュールの修理 Repairing BASIC MODULE 500E500 W124
http://mercedesbenznetcom.blog81.fc2.com/blog-entry-239.html
2015/1/19(月) 午後 2:53返信する
BAS/EPS ABS警告灯について 初ベンツ 14/4/20(日) 10:45
http://www.benz-web.com/c-board/c-board.cgi?cmd=ntr;tree=15732;id=w202
2015/1/19(月) 午後 2:59返信する
W210 Eクラス 変速不良
http://techno-auto.seesaa.net/article/391748036.html
2015/1/19(月) 午後 3:05返信する
W210エンジン始動出来ず。
リレーモジュール”の故障でした。
エンジン始動時にこのリレーモジュールから出る指示信号が
フューエルポンプを閉じさせていたのです。
セルは回るが燃料が来なければ、エンジンはかかりません。
リレーモジュールの修理は無理なので、新品へと交換と
なりました。 お値段は部品価格約34000円ほど
http://autosolution.sblo.jp/article/32480611.html
2015/1/19(月) 午後 3:22返信する