BW:318Ci:E46:GH-BX20:ALIGNMENT:[BMW318]447:IG COIL:BOSCH:0221504464:G-scan:DTC:29CC:29CD:2E24: 2006MY [2005.07.07] 15069-0003
73100km 2013.05.24 53100km 2011.06.03 3xxxx 2009.
G-scan[2013.10.23] DTC:
29CC:Combustion misfires,several cylinders / Combustion miss ,bank 2,several cylinders 29CD:Combustion misfires,cylinder 1 2E24:Ignition coil, cylinder 1 / Alternator / Generator, electric
DME:
Ne: 0 rpm ペダルセンサ電圧2 : 0.35 V DISAポテンションメーター電圧: 0.00 V スロットル開口部: 7.1 % [TPS.スロットル開度] AFM : 0.0 kg/h 相対エアチャージ : 100.0 % 噴射継続 : 0.00 ms [INJ ?] スパーク進角 : 0.0 'cr 負荷信号 : 59.7 % 差圧インテークマニホールド : 0.0 mbar アクセルペダルポジション : 0.0 % ペダルセンサ電圧 1 : 0.71 V
吸気温度 : 23.2 ℃ 周囲温度 : 15.7 ℃ 冷却水温エンジン : 15.7 ℃ ラジエータ出口クーラント... : 15.7 ℃ バッテリー電圧 : 11.9 V 車速 : 0 km/h アイドル回転数実測値 : 0 rpm アイドル回転数規定値 : 1290 rpm ノック信号シリンダー 1 : 7.81 V ノック信号シリンダー 2 : 0.00 V ノック信号シリンダー 3 : 0.00 V ノック信号シリンダー 4 : 7.81 V
追加ラムダ適応シリンダー ... : 0.54 [単位表示なし] 追加ラムダ適応シリンダー ... :-0.02 [単位表示なし] リフトインレットバルブ: 1.48 mm バノスポジション吸気 : 120.00 'cr [°CR ] バノスポジション排気 : 120.00 'cr [°CR ] バノス適応吸気 : 117.90 'cr [°CR ] バノス適応排気 : 54.00 'cr [°CR ]
GF-AL19
CAMber: Front:-0°20'+-30'
CASter:5°48'+-0.5° KP:King Pin: 15°22'+-0.5°
side slip:in 5+-5 toe-in: 3+-1
max.turning angle: outside:36° in side:44°
wheel base :2725mm
tread: Front:1480mm Rear: 1490mm
E-BE19
CAMber: Front:-0°51'+-30'
CASter:3°59'+-0.5° KP:King Pin: 15°37'+-0.5°
side slip:in 5+-5 toe-in: 3+-1
max.turning angle: outside:34° in side:41°
wheel base :2700mm
tread: Front:1410mm Rear: 1420mm
|
http://www.euro-revolution.net/bmwrace/setting.html
http://www.ehow.com/about_6401371_alignment-specifications-1997-bmw-318i.html
2010/12/30(木) 午後 10:16返信する
BMW 318i Front Wheel Alignment Specifications
The toe angle (total) for the 318i without the sport suspension package is 0° 18' ±8'. The camber measurement is -0 40' ±30'. There are two Caster alignment values---one at a 10° wheel lock and another for a 20° wheel lock. At the 10° wheel lock, the specification is 3° 50' ±30'. At the 20° wheel lock, use 3° 57' ±30'.
2010/12/30(木) 午後 10:18返信する
BMW 318i Rear Wheel Alignment Specifications
For the rear wheel alignment, use a toe angle (total) of 0° 24' ±6'. The camber is -1° 40' ±15'. There is a maximum allowable deviation between sides of 0° ±3'.
2010/12/30(木) 午後 10:18返信する
BMW 318i Sport Suspension Front Wheel Alignment Specifications
The toe angle (total) for the 1997 BMW 318i with Sport Suspension is 0° 18' ±8'. The camber measurement is -0° 51 ± 30'. There are two different alignment specifications for the caster---one at a 10° wheel lock and one at a 20° wheel lock. At 10°, the specification is 3° 50' ±30'. At a 20° wheel lock, the alignment is 3° 57' ±30'. Finally, set the front wheel displacement at 0° ±15'.
2010/12/30(木) 午後 10:19返信する
BMW 318i Sport Suspension Rear Wheel Alignment Specifications
Set the toe angle (total) to 0° 24' ±6' and set the camber to -2° 24' ±6'. Note that there is a maximum allowable deviation between sides of 0° ±3'.
Safety
Make sure to use the appropriate safety precautions when working on your car. Take your car to a certified mechanic if you do not feel comfortable with your abilities or if you do not have the proper equipment.
2010/12/30(木) 午後 10:20返信する
http://www.honestjohn.co.uk/forum/post/index.htm?t=20254
2010/12/30(木) 午後 11:24返信する
When do I need a wheel alignment on e90 325i?
Hi, I just installed 4 new michelin tires from Costco, how do I know I need a wheel alignment?
http://answers.yahoo.com/question/index?qid=20070826164135AAWQ2JE
2010/12/30(木) 午後 11:26返信する
if your car can drive a straight line on its own. drive on sevral different roads. drive straight and if your car drift over a certain direction then you need an alignment. repeat this on several roads some roads tilt more than others
if its bad enough you can see it park with your steering wheel straight and get in front of the car and look at the tires it theyre pointing in a different direction or angled in/out..go get them aligned other wise youll need new tires sooner.
2010/12/30(木) 午後 11:27返信する
Drive the car in a straight raod and check whether it is pulling any side.If it pulls then you need an alignment.Do it immedaitely.Because an un alligned wheel will affect the tyres.
2010/12/30(木) 午後 11:28返信する
A lot of places will check the alignment for free. Most people have it checked and/or adjusted when they buy a set of tires. If your car tends to drift to one direction, or if the tires are wearing unevenly, you probably need an alignment job.
2010/12/30(木) 午後 11:29返信する
First of all, if your car was equipped with runflat tires in order to not have problems with warranty for vibration, tire wear problems you should buy BMW factory tires. You should have a wheel alignment done when 4 tires are replaced. When an alignment is done, you should always go to an authorized
2010/12/30(木) 午後 11:31返信する
BMW dealer because there are electronic sensors and safety monitoring equipment that need reset by the dealer following the alignment. Also, your dealer will use, a machine designed for BMW's.
Source(s):
Married to BMW Master Tech
2010/12/30(木) 午後 11:31返信する
It's good practise to get an alignment every time you get new tyres, especially if you're buying spendy tyres like Michelin.
The alignment can be out even if the car is driving straight.
2010/12/30(木) 午後 11:32返信する
BMW 3 Series Forum - Technical Talk on the BMW E46 Forum for all BMW 3 series models from 1999 - approx 2006
http://www.bimmerforums.co.uk/forum/f18/2000-e46-318-tyre-wear-problem-t61469/
2010/12/30(木) 午後 11:36返信する
29CC Misfire Several Cylinders
29CD Misfire Cyl 1
2E24 Ignition Coil Cyl 1
http://www.justanswer.co.uk/car/7pjzf-bmw-2004-520i-anyone-explain-code-276c.html
2013/10/24(木) 午前 6:10返信する
DTC
http://www.endtuning.com/bmwcodes.html
2013/10/24(木) 午前 6:55返信する
DLC:
323i: my BMw 323i 1999 makes a lot of noise, it has around
Customer Question
my BMw 323i 1999 makes a lot of noise, it has around 700-800 rpm while in neutral, and I can't find the scanner port, what can I do? Thank you!
http://www.justanswer.com/bmw/7m1ku-323i-bmw-323i-1999-makes-lot-noise-around.html
2013/10/24(木) 午前 7:05返信する
車種が表題とは、上記の(拝借した1枚目の写真)と違うが、DLCの配置形状は類似(ピンの対応については未確認)している。
2013/10/24(木) 午前 7:11返信する
BW:E46:323i
AirBagのシステム KTS650でみつからず
現車のターゲット端子がない?
http://blog.hokkeji.com/?eid=799118
2015/4/25(土) 午後 0:50返信する
トラックバックされた記事
SB:BL5:B4:Alignment:左にクルマが流れて
SB:BL5:B4:Alignment:左にクルマが流れて 高速道路を3名乗車(後席は左側に乗車)で走っていると、追い越し車線であっても左にクルマが流れていく感じがして、ステアリングホイールを常に押さえておかねばならないことが気になっていた。 BL5D ホイールアライメント測定・調整 http://gonta1.web.fc2.com/bl07.htm#t アライメント調整 Part 2 http://gonta1.web.fc2.com/alignment.htm#t
2011/1/4(火) 午前 11:06 [ 車QF ]
Bobinas Bosch 0221504464 Para BMW 120i/318Ti/320i/325i/3 ...
Bobinas Bosch 0221504464 Para BMW 120i/318Ti/320i/325i/330i/525i/X3/X5/Z4 http://www.lacasadelasbujias.com.ar/catalog/product/view/4248-bobinas-bosch-0221504464-para-bmw-120i-318ti-320i-325i-330i-525i-x3-x5-z4...
2013/10/24(木) 午前 7:49 [ 車QF ]
トラックバック先の記事
全96ページ
[61] [62] [63] [64] [65] [66] [67] [68] [69] [70]